Diagnostic Procedure
AIRBAG INDICATOR ON WITHOUT ACTIVE TROUBLE CODES SYMPTOM CHART
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 |
NOTE:
Ensure the battery is fully charged. Turn the ignition on.Make sure that all active DTC's have been repaired before performing this procedure.With the DRBIII® select the PASSIVE RESTRAINTS, AIRBAG, MONITOR DISPLAY and read the WARNING LAMP STATES.With no active DTCs, Does the LAMP REQ by ACM monitor show ON?Yes --> Replace the Airbag Control Module in accordance with Service Instructions.Perform AIRBAG VERIFICATION TEST - VER 1
.No --> Refer to INSTRUMENT CLUSTER CATEGORY
symptom list for problems related to Instrument Cluster.Perform AIRBAG VERIFICATION TEST - VER 1
.
NOTE:
When reconnecting Airbag system components, the ignition must be turned, off and the battery must be disconnected.
|
All |