Diagnostic Procedure
REAR WIPER PARK INPUT SHORT-BCM SYMPTOM CHART
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition on. With the DRBIII®, clear all BCM DTC's. Turn the Rear Wipers ON. With the DRBIII®, read the DTC information. Does the DRBIII® read: Rear Wiper Park Input Short? Yes --> Go To 2 No --> The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires. Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 2 | Turn the ignition off. Disconnect the Wiper/Washer Switch harness connector. Turn the ignition on. With the DRBIII®, read DTCs. Does the DRBIII® display: Rear Wiper Park Input Short? Yes --> Replace the Wiper/Washer Switch in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 3 |
All |
| 3 | Turn the ignition off. Disconnect the Wiper/Washer Switch harness connector. Disconnect the BCM C3 harness connector. Measure the resistance between ground and the Rear Wiper Park Switch Sense circuit. Is the resistance below 5.0 ohms? Yes --> Repair the Rear Wiper Park Switch Sense circuit for a short to ground. Perform BODY VERIFICATION TEST - VER 1 . No --> Replace the Body Control Module in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . |
All |