Diagnostic Procedure
FRONT WIPER HI/LO RELAY SHORT TO BATTERY-IPM SYMPTOM CHART
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition off. Remove the Wiper Hi/Low Relay from the IPM. Disconnect the IPM C8 harness connector. Turn the ignition on. Measure the voltage of the Wiper Hi/Low Relay Control circuit at the IPM connector. Is the voltage above 1.0 volt? Yes --> Repair the Wiper Hi/Low Relay Control circuit for a short to battery. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 2 |
All |
| 2 | Install a substitute relay in place of the Wiper Hi/Low Relay. Turn the ignition on. Turn the wipers on. Does the system operate correctly? Yes --> Replace the Wiper Hi/Low Relay. Perform BODY VERIFICATION TEST - VER 1 . No --> Test Complete. |
All |