LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Pacifica Limited >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures - Diagnostic Information And Procedures - Power Windows, Telecommunication, Vehicle Theft/Security, Windshield Wiper & Washer, Verification Tests >> Vehicle Theft/Security >> Symptom: *VTSS INDICATOR INOPERATIVE >> Diagnostic Procedure

Diagnostic Procedure

VTSS INDICATOR INOPERATIVE SYMPTOM CHART

TEST ACTION APPLICABILITY
1 Disconnect the Instrument Panel Switch Pod connector.
Measure the voltage of the Fused B+ circuit.
Is the voltage above 10.0 volts?
Yes --> Go To 2
No --> Repair the Fused B+ circuit for an open.
Perform VTSS VERIFICATION TEST - 1A  .		 All
2 Disconnect the Instrument Panel Switch Pod connector.
Connect a voltmeter positive probe to a 12.0 volt supply and connect the ground probe to the VTSS Indicator Driver circuit at the I/P Switch Pod connector.
Turn the ignition on.
With the DRBIII® under BCM, actuate the VTSS Indicator lamp.
Is the voltage above 10.0 volts when the VTSS Indicator lamp is actuated?
Yes --> Replace the Instrument Panel Switch Pod assembly.
Perform VTSS VERIFICATION TEST - 1A  .
No --> Go To 3		 All
3 Disconnect the Instrument Panel Switch Pod connector.
Disconnect the BCM C4 harness connector.
Measure the resistance of the VTSS Indicator Driver circuit between the I/P Pod connector and the BCM C4 connector.
Is the resistance below 5.0 ohms?
Yes --> Replace and program the Body Control Module.
Perform VTSS VERIFICATION TEST - 1A  .
No --> Repair the VTSS Indicator Driver circuit for an open.
Perform VTSS VERIFICATION TEST - 1A  .		 All
scientia non olet · About LEMON Manuals