LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Pacifica Limited >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures - Diagnostic Information And Procedures - Power Windows, Telecommunication, Vehicle Theft/Security, Windshield Wiper & Washer, Verification Tests >> Telecommunication >> Symptom: RPM MESSAGE NOT RECEIVED >> Diagnostic Procedure

Diagnostic Procedure

RPM MESSAGE NOT RECEIVED SYMPTOM CHART

TEST ACTION APPLICABILITY
1 Start and idle the engine.
With the DRBIII®, select Engine and read the Engine RPM.
Was the DRBIII® able to I/D or communicate with the PCM and read RPM?
Yes --> Go To 2
No --> Refer to the COMMUNICATION category for the related symptom(s).
Perform BODY VERIFICATION TEST - VER 1  .		 All
2 With the DRBIII®, erase DTC's.
Cycle the ignition switch from off to on and wait approximately 1 minute.
With the DRBIII®, read DTC's.
Did this DTC reset?
Yes --> Replace and program the Hands Free Module in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1  .
No --> Test Complete.		 All
scientia non olet · About LEMON Manuals