LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Pacifica Limited >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures - Diagnostic Information And Procedures - Power Windows, Telecommunication, Vehicle Theft/Security, Windshield Wiper & Washer, Verification Tests >> Telecommunication >> Symptom List: PRNDL MESSAGE MISSING; VEHICLE SPEED MESSAGE MISSING >> Diagnostic Procedure

Diagnostic Procedure

PRNDL MESSAGE MISSING SYMPTOM CHART

TEST ACTION APPLICABILITY
1
NOTE: If the TPM indicator is illuminated, check for a low tire pressure condition. If the TPM indicator is flashing, check for DTC's.
NOTE: The below test is to locate the Tire Pressure Sensor/Transmitter.
NOTE: If the tires have been rotated, the Tire Pressure Sensor/Transmitters are no longer in sequence from the factory. Faults are linked to Sensor/Transmitter ID's.
NOTE: You must determine which Tire Pressure Sensor/Transmitter has set the fault or alert before diagnosing the system correctly.
NOTE: Set ALL tire pressures to recommended specifications and recheck for faults/alerts.
The fault will set within two minutes when at 20 PSI.Starting with the left front wheel, deflate the tire down to 20 PSI and wait 2 minutes.If the TPMS fault was detected and associated to this Sensor/Transmitter, it would correspond to the left front Sensor/Transmitter.If the TPMS fault was detected and not associated to this Sensor/Transmitter, repeat the process until the faulty Sensor/Transmitter has been identified.
NOTE: Once a fault/alert has set, it will establish the location of the Tire Pressure Sensors/Transmitter. Repeat steps until the applicable Tire Pressure Sensor/Transmitter has been located.
Perform this procedure prior to Symptom diagnosis .ContinueGo To 2
All
2 Cycle the ignition switch from OFF to ON.
With the DRBIII®, record DTC's.
Drive the vehicle.
With the DRBIII®, read the PCM DTC's.
Does the DRBIII® display any PCM DTC's?
Yes --> Refer to POWERTRAIN DIAGNOSTIC PROCEDURES for the related symptom(s).
Perform TIRE PRESSURE VERIFICATION TEST - VER 1 - SKREEM  .
No --> Go To 3
All
3 Cycle the ignition switch from OFF to ON.
With the DRBIII®, monitor the Instrument Cluster's Vehicle Speed or PRNDL data.
Does the DRBIII® display Vehicle Speed or PRNDL data?
Yes --> Check connectors - Clean/repair as necessary. Replace and program the SKREEM in accordance with the Service Information.
Perform TIRE PRESSURE VERIFICATION TEST - VER 1 - SKREEM  .
No --> Refer to BODY COMMUNICATION for the related symptom(s).
Perform TIRE PRESSURE VERIFICATION TEST - VER 1 - SKREEM  .
All