Diagnostic Procedure
TCM MESSAGES NOT RECEIVED SYMPTOM CHART
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 |
NOTE:
Ensure the TCM communicates on the PCI bus.
NOTE:
Diagnose and repair any TCM DTCs before proceeding with this test. Turn the ignition on, engine not running.With the DRBIII®, monitor the Park/Neutral Position Switch input state.Move the gear selector through all gear positions.Does the DRBIII® display Park/Neutral and Drive/Reverse in the correct gear positions?Yes --> With the DRBIII®, erase DTCs. Turn the ignition off, wait 10 seconds, then turn the ignition on. With the DRBIII®, read DTCs.If this code resets, replace the Overhead Console in accordance with the Service Information.Perform BODY VERIFICATION TEST - VER 1
.No --> Refer to *CHECKING PARK/NEUTRAL SWITCH OPERATION in the TRANSMISSION - NGC article.Perform BODY VERIFICATION TEST - VER 1
. |
All |