Diagnostic Procedure
RIGHT TURN SIGNAL INDICATOR SHORT - BCM SYMPTOM CHART
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition off. Disconnect the BCM C4 harness connector. Turn the ignition on. With the DRBIII®, erase DTCs. Does the RIGHT TURN SIGNAL INDICATOR SHORT reset? Yes --> Replace the BCM in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 2 |
All |
| 2 | Turn the ignition off. Disconnect the BCM C4 harness connector. Disconnect the Instrument Cluster C1 harness connector. Measure the resistance between ground and the Right Turn Signal circuit. Is the resistance below 5.0 ohms? Yes --> Repair the Right Turn Signal circuit for a short to ground. Perform BODY VERIFICATION TEST - VER 1 . No --> Replace the Instrument Cluster in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . |
All |