Diagnostic Procedure
EVIC SWITCH INPUT STUCK SYMPTOM CHART
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 |
NOTE:
Diagnose and repair any EVIC Switch Input Short or Open DTC's before proceeding with this test. With the DRBIII®, record and erase DTC's.Cycle the ignition switch from ON to OFF to ON.With the DRBIII®, read DTC's.Wait 30 seconds.Does the DRBIII® display EVIC SWITCH INPUT STUCK?Yes --> Replace the Instrument Panel Switch Pod in accordance with the Service Information.Perform BODY VERIFICATION TEST - VER 1
.No --> The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors for an intermittent condition.Perform BODY VERIFICATION TEST - VER 1
. |
All |