Diagnostic Procedure
FRONT MODE DOOR TRAVEL TOO SMALL (ACTIVE) SYMPTOM CHART
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition on. With the DRBIII®, read the active ATC DTCs. Does the DRBIII® display: FRONT MODE DOOR NOT RESPONDING? Yes --> Return to the Heating & A/C symptom list and choose the symptom. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 2 |
All |
| 2 | Turn the ignition off. Disconnect the Front Mode Door Actuator harness connector. Connect a 12-volt Test Light between the Front Mode Door Actuator harness connector cavities. Turn the ignition on. While monitoring the test light, press the MODE switch to place the mode door in each position.
NOTE:
Observe test light for approximately 30 seconds. Does the test light start to flash and stay flashing? Yes --> Go To 3 No --> Replace the Automatic Temperature Control (ATC) in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 3 | Remove the Front Mode Door Actuator from the A/C-Heater Housing assembly. Rotate the front mode door from stop to stop. Note: The door should rotate approximately 45 degrees from stop to stop. Does the front mode door move smoothly in both directions? Yes --> Replace the Front Mode Door Actuator in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . No --> Repair or replace the front mode door as necessary in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . |
All |