LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Pacifica Limited >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body - Interior & Exterior >> Sunroof >> Glass Panel >> Adjustments >> Sunroof Glass Panel Adjustment

Sunroof Glass Panel Adjustment

  1. Move the sunshade rearward to the open position.
  2. Move the sunroof glass panel to the fully closed position.
  3. Loosen the forward attaching screws on each side enough to make the front of the glass to adjust up or down.
  4. Adjust the front surface of the sunroof glass panel 0.00 mm to 1.75 mm (0.00 in. to 0.07 in.) below the top surface of the roof.
  5. Tighten the front glass panel attaching screws to 3.5 N.m (31 in. lbs.) torque. See Figure.
  6. Loosen the rear screws on each side enough to make the rear adjustment. See Figure.
  7. Adjust the rear surface of the sunroof glass panel 0.00 mm to 1.75 mm (0.03 in. to 0.07 in.) above the top surface of the roof.
  8. Tighten the rear glass panel attaching screws to 3.5 N.m (31 in. lbs.) torque. See Figure.
  9. Check for proper fit. If not OK, repeat glass panel adjustment.
scientia non olet · About LEMON Manuals