LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Exhaust System & Turbocharger >> Lines And Hoses >> Installation - Lines And Hoses >> Coolant Supply Line

Coolant Supply Line

  1. If brass fitting was removed from engine block, apply thread sealer to threads and install in engine block. Torque brass fitting to 41 N.m (30 ft. lbs.).
  2. Position coolant supply line to mounting location.
  3. Install NEW   washers on banjo fitting of coolant supply line. See Figure. Hand start banjo bolt.
  4. Hand start flared fitting of coolant supply line.
  5. Torque banjo fitting bolt to 30 N.m (22 ft. lbs.). See Figure.
  6. Torque flared fitting to 31 N.m (23 ft. lbs.). See Figure.
  7. Lower vehicle.
  8. Fill cooling system (Refer to COOLING/ENGINE - STANDARD PROCEDURE) .
scientia non olet · About LEMON Manuals