LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Exhaust System & Turbocharger >> Charge Air Cooler And Hoses >> Removal >> Removal - Charge Air Cooler Hoses >> Hose - Charge Air Cooler To Throttle Body

Hose - Charge Air Cooler To Throttle Body

  1. Remove air cleaner housing. Refer to AIR CLEANER HOUSING .
  2. Disconnect negative battery cable.
  3. Disconnect positive battery cable.
  4. Remove battery and battery tray (Refer to ELECTRICAL/BATTERY SYSTEM/BATTERY - REMOVAL) .
  5. Remove battery tray support bracket.
  6. Loosen hose clamp at charge air cooler. See Fig 1.
  7. Dislodge hose from charge air cooler.
  8. Disconnect Inlet Air Temperature (IAT) sensor connector. See Fig 2.
  9. Disconnect Throttle Inlet Pressure (TIP) hose from charge air cooler hose. See Fig 2.
  10. Loosen hose clamp at throttle body.
  11. Remove charge air cooler hose.
Fig 1: Charge Air Cooler Hoses
GC0019344Courtesy of DAIMLERCHRYSLER CORP.
1 - HOSE - CHARGE AIR COOLER TO THROTTLE BODY
2 - CHARGE AIR COOLER
3 - HOSE - TURBOCHARGER TO CHARGE AIR COOLER
Fig 2: IAT Sensor - 2.4L Turbo
GC0019359Courtesy of DAIMLERCHRYSLER CORP.
1 - HOSE - CHARGE AIR COOLER TO THROTTLE BODY
2 - IAT SENSOR
3 - TIP HOSE
scientia non olet · About LEMON Manuals