Front Bumper Fascia: Installation

Place fascia on a work bench
Install lower radiator grille chrome strips, if equipped. Place chrome strip into position, and press on chrome strip until it is locked into position.

Fig 1: Front Fascia - Lower Grille Chrome A

Courtesy of DAIMLERCHRYSLER CORP.

1 - FRONT FASCIA

2 - SPRING NUTS (6)

3 - PUSH PIN FASTENER

4 - LOWER RADIATOR GRILLE

5 - CHROME STRIPS

Install air dam, retainer fasteners, foam and fog lamps if equipped. See Fig 3.
Place fascia in position and connect fog lamp wire connectors.
Install two fasteners attaching fascia to the fender bracket. See Fig 2.

Fig 2: Front Fascia Attaching Points
Courtesy of DAIMLERCHRYSLER CORP.

1 - ATTACHING POINTS

2 - FRONT FASCIA
Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE) .
Install three screws attaching air dam and lower fascia to the radiator support crossmember.
Install spring nuts fasteners attaching fascia to fender flange. See Fig 3.
Install three screws attaching splash shield to fascia on each side of vehicle.
Lower vehicle.
Install radiator grille. (Refer to BODY/EXTERIOR/GRILLE - RADIATOR - INSTALLATION)

Fig 3: Front Bumper Fascia

Courtesy of DAIMLERCHRYSLER CORP.

1 - FRONT BUMPER FASCIA

2 - FRONT BUMPER ENERGY FOAM

3 - RADIATOR AIR DAM