LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Interior & Exterior >> Weatherstrip/Seals >> Header / A-Pillar Weatherstrip -Pt-27 >> Removal >> Removal - Pt-27 Only

Removal - Pt-27 Only

  1. Lower convertible top.
  2. Remove door sill scuff plate. (Refer to BODY/INTERIOR/DOOR SILL TRIM - REMOVAL) .
  3. Starting on left side of vehicle. See Fig 1.
  4. Remove header molding. (Refer to BODY/EXTERIOR/MOLDING - REMOVAL) .
  5. Remove two screws on the top of header.
  6. Pull weatherstrip away to access weatherstrip retainer.
  7. Remove four screws and weatherstrip retainer at A-pillar.
  8. Remove one screw attaching windshield molding.
  9. Right side of vehicle.
  10. Remove two screws on the top of header.
  11. Pull weatherstrip away to access weatherstrip retainer.
  12. Remove four screws and weatherstrip retainer at A-pillar.
  13. Remove one screw attaching windshield molding.
  14. Pull weatherstrip away from vehicle.
Fig 1: HEADER AND A-PILLAR WEATHERSTRIP
GC0022609Courtesy of DAIMLERCHRYSLER CORP.
1 - WINDSHIELD OPENING FRAME
2 - ATTACHING SCREWS
3 - HEADER AND A-PILLAR WEATHERSTRIP
4 - PUSH PIN FASTENER
scientia non olet · About LEMON Manuals