LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Interior & Exterior >> Sunroof >> Glass Panel >> Adjustments >> Sunroof Glass Panel Adjustment

Sunroof Glass Panel Adjustment

  1. Move the sunshade rearward to the open position.
  2. Move the sunroof glass panel to the fully closed position.
  3. Loosen the forward attaching screws on each side enough to make the front of the glass to adjust up or down. See Figure.
  4. Adjust the front surface of the sunroof glass panel 1.75 mm to 2.75 mm (0.07 in. to 0.11 in.) below the top surface of the roof.
    NOTE: Top of the glass seal is 2.5 mm (0.1 in.) higher than the surface of the sunroof glass. Measure at 300 mm (11.8 in.) outboard of the center line of the vehicle.
  5. Tighten the front glass panel attaching two screws to 3.5 N.m (31 in. lbs.) torque. See Figure.
  6. Loosen the rear screws on each side enough to make the rear adjustment. See Figure.
  7. Adjust the rear surface of the sunroof glass panel 0.75 mm to.75 mm (0.03 in. to 0.07 in.) below the top surface of the roof.
  8. Tighten the rear glass panel attaching two screws to 3.5 N.m (31 in. lbs.) torque. See Figure.
  9. Check for proper fit. If not OK, repeat glass panel adjustment.
scientia non olet · About LEMON Manuals