Removal - Pt-27 Only

Remove seat from vehicle. (Refer to BODY/SEATS/SEAT - REMOVAL) .
Remove upper riser shield, if equipped.
Remove the seat back recliner handle/fold flat handle and front seat cushion shield. See Fig 1.

Disconnect wire connectors, if equipped. See Fig 2.

Fig 1: HANDLES

GC0022474

Courtesy of DAIMLERCHRYSLER CORP.

1 - TILT FORWARD HANDLE

2 - ATTACHING SCREWS

3 - RECLINING HANDLE

Fig 2: SEAT SIDE SHIELD WIRE CONNECTORS

GC0022461

Courtesy of DAIMLERCHRYSLER CORP.

1 - WIRE CONNECTORS

Remove front inner seat belt attaching screw and inboard seat side shield. See Fig 3.

Fig 3: SIDE SHIELD
Courtesy of DAIMLERCHRYSLER CORP.

1 - SIDE CUSHION SHIELD

2 - SEAT BELT ATTACHING BOLT
Remove front seat cushion screws, two front side and two rear. See Fig 4 and Fig 5.

Fig 4: FRONT SEAT CUSHION - FRONT SIDE
Courtesy of DAIMLERCHRYSLER CORP.

1 - ATTACHING SCREWS

2 - TOWEL BAR

Fig 5: FRONT SEAT CUSHION - REAR
Courtesy of DAIMLERCHRYSLER CORP.

1 - ATTACHING SCREWS
Disconnect any electrical connectors and wire ties from the bottom of seat cushion, if equipped. See Fig 6.

Fig 6: FOLD FLAT CABLE AND WIRE HARNESS
Courtesy of DAIMLERCHRYSLER CORP.

1 - FASTENER
Remove seat cushion from seat frame. See Fig 7.

Fig 7: SEAT CUSHION, FOAM AND SEAT PAN

GC0022504

Courtesy of DAIMLERCHRYSLER CORP.