LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Crossfire SRT-6, 2D Coupe >> Repair and Diagnosis >> Electrical >> Gauges >> Interior & Exterior (Service Information) >> Interior >> Headliner >> Removal

Interior & Exterior (Service Information): Interior: Headliner: Removal

Fig 1: Removing Dome Lamp Assembly
GC0033317Courtesy of DAIMLERCHRYSLER CORP.
  1. Remove the dome lamp assembly (2) by gently prying off the lens using a trim stick (1) or equivalent.
    Fig 2: Removing/Installing Dome Lamp Assembly Retaining Screws
    GC0033318Courtesy of DAIMLERCHRYSLER CORP.
  2. Remove the two retaining screws (1) and pull the dome lamp assembly from the headliner.
    Fig 3: Disconnecting/Connecting Dome Lamp Assembly Harness Connector
    GC0033319Courtesy of DAIMLERCHRYSLER CORP.
  3. Disconnect the dome lamp assembly harness connector (1) and remove the dome lamp assembly.
    Fig 4: Identifying Universal Transmitter
    GC0032973Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove the universal garage door opener/TPM module (1) from the headliner using a trim stick or equivalent. Pull the module from the headliner and disconnect the harness connector.
  5. Remove both the right and left sun visor assemblies.
    Fig 5: Identifying A-Pillar Trim
    GC0033266Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove the right and left A-pillar trim panels.
  7. Tilt both seats all the way forward and all the way down.
    Fig 6: Removing/Installing Rear Interior Trim Panel
    GC0033320Courtesy of DAIMLERCHRYSLER CORP.
  8. Disengage rear interior trim panel (2) retaining clips near headliner.
  9. Remove the rear headliner retaining clips (1).
  10. Remove the headliner from the passenger door opening.