When Monitored and Set Condition
- When Monitored: With the ignition on.
- Set Condition: This DTC is set when a CAN ID was not received in the required time from the Transmission Control Module (TCM).
| POSSIBLE CAUSES |
|---|
| OPEN CAN C BUS (+)/(-) CIRCUIT |
| CAN C BUS (+)/(-) CIRCUIT SHORTED TO GROUND |
| CAN C BUS (+)/(-) CIRCUIT SHORTED TO VOLTAGE |
| TRANSMISSION CONTROL MODULE |
| SENTRY KEY REMOTE ENTRY MODULE |
| POWERTRAIN CONTROL MODULE |
For a complete Instrument Cluster Circuit Diagram, (Refer to ELECTRICAL/INSTRUMENT CLUSTER - SCHEMATICS AND DIAGRAMS) .