LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Sebring Limited, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Air Bag Restraint Systems - Except Coupe) >> Diagnostic Tests >> Test 8A: Right Curtain Squib Circuit Open

Test 8A: Right Curtain Squib Circuit Open

WARNING: This page is about a different variant/trim than selected.
NOTE: Prior to performing any air bag system test, go to PRETEST INSPECTION & DIAGNOSTIC PROCEDURE  under DIAGNOSTICS. Perform TEST VER-1: AIR BAG VERIFICATION TEST  after all repairs unless otherwise directed.
This procedure applies to Sebring and Stratus sedan models only.
  1. Turn ignition switch to ON position. Using DRBIII, determine if RIGHT CURTAIN SQUIB CIRCUIT OPEN is active or stored Diagnostic Trouble Code (DTC). If RIGHT CURTAIN SQUIB CIRCUIT OPEN is an active DTC, go to next step. If RIGHT CURTAIN SQUIB CIRCUIT OPEN is a stored DTC, go to TEST 1B: REPAIRING STORED CODES .
  2. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Access right curtain air bag and disconnect harness connector. See CURTAIN (HEAD IMPACT) AIR BAG MODULE  under REMOVAL & INSTALLATION. Connect appropriate SRS load tool to right curtain air bag harness connector. Turn ignition switch to ON position. Connect negative battery cable. Using DRBIII, read DTCs. If DRBIII displays RIGHT CURTAIN SQUIB CIRCUIT OPEN, go to next step. If DRBIII does not display RIGHT CURTAIN SQUIB CIRCUIT OPEN, replace right curtain air bag module.
  3. Turn ignition switch to OFF position. Disconnect negative battery cable and wait at least 2 minutes. Access Occupant Restraint Controller (ORC) and disconnect harness connector. See OCCUPANT RESTRAINT CONTROLLER (ORC)  under REMOVAL & INSTALLATION. Connect appropriate SRS load tool adapter to ORC harness connector. Measure resistance in right curtain air bag line 1 circuit (Light Blue/Yellow wire) between load tool adapter and right curtain air bag harness connector. See WIRING DIAGRAMS . Measure resistance in right curtain air bag line 2 circuit (Light Blue/White wire) between load tool adapter and right curtain air bag harness connector. If resistance is less than one ohm in both circuits, replace ORC. If resistance is more than one ohm in either circuit, repair open in appropriate circuit.
scientia non olet · About LEMON Manuals