LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Sebring Limited, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Air Bag Restraint Systems - Except Coupe) >> Diagnostic Tests >> Test 33A: Passenger SBT Circuit Short

Test 33A: Passenger SBT Circuit Short

WARNING: This page is about a different variant/trim than selected.
NOTE: Prior to performing any air bag system test, go to PRETEST INSPECTION & DIAGNOSTIC PROCEDURE  under DIAGNOSTICS. Perform TEST VER-1: AIR BAG VERIFICATION TEST  after all repairs unless otherwise directed.
  1. Turn ignition switch to ON position. Using DRBIII, determine if PASSENGER SBT CIRCUIT SHORT is active or stored Diagnostic Trouble Code (DTC). If PASSENGER SBT CIRCUIT SHORT is an active DTC, go to next step. If PASSENGER SBT CIRCUIT SHORT is a stored DTC, go to TEST 1B: REPAIRING STORED CODES .
  2. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Access passenger-side seat belt pretensioner and disconnect harness connector. See SEAT BELT PRETENSIONER  under REMOVAL & INSTALLATION. Connect appropriate SRS load tool to passenger-side seat belt pretensioner harness connector. Turn ignition switch to ON position. Connect negative battery cable. On DRBIII, read active DTCs. If DRBIII displays PASSENGER SBT CIRCUIT SHORT, go to next step. If DRBIII does not display PASSENGER SBT CIRCUIT SHORT, replace passenger-side seat belt pretensioner.
  3. Turn ignition switch to OFF position. Disconnect negative battery cable and wait at least 2 minutes. Access and disconnect Occupant Restraint Controller (ORC) connector. See OCCUPANT RESTRAINT CONTROLLER (ORC)  under REMOVAL & INSTALLATION. Connect appropriate SRS load tool adapter to harness side of ORC connector. Remove load tool from passenger-side seat belt pretensioner harness connector. Measure resistance between passenger-side seat belt pretensioner line 1 circuit (Light Blue/Dark Green wire) and line 2 circuit (Light Blue/Yellow wire) on harness side of pretensioner connector. See WIRING DIAGRAMS . If resistance is more than 10 k/ohms, replace ORC. If resistance is less than 10 k/ohms, repair short between Light Blue/Dark Green and Light Blue/Yellow wires.
scientia non olet · About LEMON Manuals