LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Sebring Limited, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Air Bag Restraint Systems - Except Coupe) >> Diagnostic Tests >> Test 30A: No Cluster Message

Test 30A: No Cluster Message

WARNING: This page is about a different variant/trim than selected.
NOTE: Prior to performing any air bag system test, go to PRETEST INSPECTION & DIAGNOSTIC PROCEDURE  under DIAGNOSTICS. Perform TEST VER-1: AIR BAG VERIFICATION TEST  after all repairs unless otherwise directed.
  1. Turn ignition switch to ON position. Using DRBIII, determine if MIC message from instrument cluster is an active or stored Diagnostic Trouble Code (DTC). If MIC message is an active DTC, go to next step. If MIC message is a stored DTC, go to TEST 1B: REPAIRING STORED CODES .
  2. Using DRBIII, ensure instrument cluster communicating on the PCI bus. If instrument cluster is communicating on the PCI bus, replace Occupant Restraint Controller (ORC). See OCCUPANT RESTRAINT CONTROLLER (ORC)  under REMOVAL & INSTALLATION. If instrument cluster is not communicating on the PCI bus, diagnose instrument cluster bus malfunction.
scientia non olet · About LEMON Manuals