LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Sebring Limited, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Air Bag Restraint Systems - Except Coupe) >> Diagnostic Tests >> Test 24A: Driver Squib 2 Circuit Short To Battery

Test 24A: Driver Squib 2 Circuit Short To Battery

WARNING: This page is about a different variant/trim than selected.
NOTE: Prior to performing any air bag system test, go to PRETEST INSPECTION & DIAGNOSTIC PROCEDURE  under DIAGNOSTICS. Perform TEST VER-1: AIR BAG VERIFICATION TEST  after all repairs unless otherwise directed.
  1. Turn ignition switch to ON position. Using DRBIII, determine if DRIVER SQUIB 2 CIRCUIT SHORT TO BATTERY is active or stored Diagnostic Trouble Code (DTC). If DRIVER SQUIB 2 CIRCUIT SHORT TO BATTERY is an active DTC, go to next step. If DRIVER SQUIB 2 CIRCUIT SHORT TO BATTERY is a stored DTC, go to TEST 1B: REPAIRING STORED CODES .
  2. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Remove driver-side air bag module. See DUAL-STAGE DRIVER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Connect appropriate SRS load tool to driver-side air bag module harness connectors. Turn ignition switch to ON position. Connect negative battery cable. On DRBIII, read active DTCs. If DRBIII displays DRIVER SQUIB 2 CIRCUIT SHORT TO BATTERY, go to next step. If DRBIII does not display DRIVER SQUIB 2 CIRCUIT SHORT TO BATTERY, replace driver-side air bag module.
  3. Turn ignition switch to OFF position. Disconnect negative battery cable and wait at least 2 minutes. Access clockspring and disconnect lower clockspring harness connector. See CLOCKSPRING  under REMOVAL & INSTALLATION. Connect appropriate SRS load tool to harness side of lower clockspring connector. Turn ignition switch to ON position. Connect negative battery cable. On DRBIII, read active DTCs. If DRBIII displays DRIVER SQUIB 2 CIRCUIT SHORT TO BATTERY, go to next step. If DRBIII does not display DRIVER SQUIB 2 CIRCUIT SHORT TO BATTERY, replace clockspring.
  4. Turn ignition switch to OFF position. Disconnect negative battery cable and wait at least 2 minutes. Access and disconnect Occupant Restraint Controller (ORC) connector. See OCCUPANT RESTRAINT CONTROLLER (ORC)  under REMOVAL & INSTALLATION. Connect appropriate SRS load tool adapter to harness side of ORC connector. Remove load tool from lower clockspring harness connector. Turn ignition switch to ON position. Connect negative battery cable. Measure voltage in driver-side air bag module line 1 circuit (Orange/Light Blue wire) between ground and harness side of clockspring connector. See WIRING DIAGRAMS . Measure voltage in driver-side air bag module line circuit (Tan/Light Blue wire) between ground and harness side of clockspring connector. If voltage is not present, replace ORC. If voltage is present, repair short to battery in appropriate wire.
scientia non olet · About LEMON Manuals