Test 10A: Right Curtain Squib Circuit Short To Battery
WARNING: This page is about a different variant/trim than selected.
NOTE:
Prior to performing any air bag system test, go to PRETEST INSPECTION & DIAGNOSTIC PROCEDURE under DIAGNOSTICS. Perform TEST VER-1: AIR BAG VERIFICATION TEST after all repairs unless otherwise directed.
This procedure applies to Sebring and Stratus sedan models only.
This procedure applies to Sebring and Stratus sedan models only.
- Turn ignition switch to ON position. Using DRBIII, determine if RIGHT CURTAIN SQUIB CIRCUIT SHORT TO BATTERY is active or stored Diagnostic Trouble Code (DTC). If RIGHT CURTAIN SQUIB CIRCUIT SHORT TO BATTERY is an active DTC, go to next step. If RIGHT CURTAIN SQUIB CIRCUIT SHORT TO BATTERY is a stored DTC, go to TEST 1B: REPAIRING STORED CODES .
- Disable air bag system. See DISABLING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM. Access right curtain air bag and disconnect harness connector. See CURTAIN (HEAD IMPACT) AIR BAG MODULE under REMOVAL & INSTALLATION. Connect appropriate SRS load tool to curtain air bag harness connector. Turn ignition switch to ON position. Connect negative battery cable. Using DRBIII, read DTCs. If DRBIII displays RIGHT CURTAIN SQUIB CIRCUIT SHORT TO BATTERY, go to next step. If DRBIII does not display RIGHT CURTAIN SQUIB CIRCUIT SHORT TO BATTERY, replace right curtain air bag module.
- Turn ignition switch to OFF position. Disconnect negative battery cable and wait at least 2 minutes. Access Occupant Restraint Controller (ORC) and disconnect harness connector. See OCCUPANT RESTRAINT CONTROLLER (ORC) under REMOVAL & INSTALLATION. Connect appropriate SRS load tool adapter to ORC harness connector. Turn ignition switch to ON position. Connect negative battery cable. Measure voltage in right curtain air bag line 1 circuit (Light Blue/Yellow wire) between load tool adapter and right curtain air bag harness connector. See WIRING DIAGRAMS . Measure voltage in right curtain air bag line 2 circuit (Light Blue/White wire) between load tool adapter and right curtain air bag harness connector. If voltage is not present in both circuits, replace ORC. If voltage is present in either circuit, repair short to battery in appropriate circuit.