LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Sebring Limited, 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Anti-Theft Systems >> Powertrain Diagnostic Procedures - NGC DRIVEABILITY Symptoms, NGC DRIVEABILITY Diagnostic Tests DTCS P0016 To P0461 - Except Coupe >> DRIVEABILITY - NGC - Diagnostic Tests >> DTC P0133: O2 Sensor 1/1 Slow Response, P0139: O2 Sensor 1/2 Slow Response >> Possible Causes

Possible Causes

GOOD TRIP EQUAL TO ZERO

EXHAUST LEAK

O2 SIGNAL CIRCUIT

O2 RETURN CIRCUIT

O2 SENSOR

DIAGNOSTIC PROCEDURE - P0133-O2 SENSOR 1/1 SLOW RESPONSE

TEST ACTION
1
NOTE: If one of the O2 Sensors Signal or Return circuits are shorted to ground or voltage, all the other O2 Sensor voltage readings will be affected.
NOTE: It is important to perform the diagnostics on the O2 Sensor that set the DTC.
NOTE: After the repairs have been made, verify proper O2 Sensor operation. If all the O2 Sensor voltage readings have not returned to normal, follow the diagnostic procedure for the remaining O2 Sensors.
NOTE: Check for contaminants that may have damaged the O2 Sensor: contaminated fuel, unapproved silicone, oil and coolant.
Ignition on, engine not running.With the DRBIII®, read DTCs and record the related Freeze Frame data.Is the Good Trip Counter displayed and equal to zero?
  1. Yes --> Go To 2
  2. No --> Refer to the INTERMITTENT CONDITION  symptom in the Driveability category.

    Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC .
2 Start the engine.
Inspect the exhaust system for leaks between the engine and the O2 Sensors.
Are there any exhaust leaks?
  1. Yes --> Repair or replace the leaking exhaust parts as necessary.

    Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC .

  2. No --> Go To 3
3 Turn the ignition off
Disconnect the O2 Sensor harness connector.
Ignition on, engine not running.
Measure the voltage on the O2 Signal circuit in the O2 Sensor harness connector.
Is the voltage between 4.5 and 5.0 volts?
  1. Yes --> Go To 4
  2. No --> Check the O2 Signal circuit for damage, short to ground, open, or short to voltage. If OK, replace and program the Powertrain Control Module in accordance with the Service Information.

    Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC .
4 Turn the ignition off.
Disconnect the O2 Sensor harness connector.
Ignition on, engine not running.
Measure the voltage on the O2 Return circuit in the O2 Sensor harness connector.
Is the voltage at 2.5 volts?
  1. Yes --> Check the O2 Return circuit for damage, short to ground, open, or short to voltage. If OK, replace and program the Powertrain Control Module in accordance with the Service Information.

    Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC .

  2. No --> Go To 5
5 If there are no possible causes remaining, view repair.
Repair:
Replace the O2 Sensor
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC .
scientia non olet · About LEMON Manuals