LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Sebring LXi, 2D Convertible >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Powertrain Diagnostic Procedures - Sentry Key Immobilizer Symptoms, Starting Symptoms, Verification Tests, Skis Verification Test, Connector PINOUTS, Schematic Diagrams, Charts And Graphs - Except Coupe >> Verification Tests >> Powertrain Verification Test VER - 1 NGC

Powertrain Verification Test VER - 1 NGC

  1. NOTE: After completing the Powertrain Verification Test the Transmission Verification Test must be performed.
  2. NOTE: If the PCM has been replaced and the correct VIN and mileage have not been programmed, a DTC will be set in the ABS Module, Airbag Module and the SKIM.
  3. NOTE: If the vehicle is equipped with a Sentry Key Immobilizer System, Secret Key data must be updated. Refer to the Service Information for the PCM, SKIM and the Transponder (ignition key) for programming information.
  4. Inspect the vehicle to ensure that all components related to the repair are connected properly.
  5. Inspect the engine oil for fuel contamination. Replace the oil and filter as necessary.
  6. Attempt to start the engine.
  7. If the No Start condition is still present, refer to appropriate symptom in STARTING  and perform the diagnostic testing as necessary. Refer to and Technical Service Bulletins that may apply.
  8. Run the engine for one warm-up cycle to verify operation.
  9. With the DRBIII®, confirm that no DTCs or Secondary Indicators are present and that all components are functioning properly.
  10. If a DTC is present, refer to the appropriate category and select the corresponding symptom.

    Are any DTCs present?

    1. Yes --> Repair is not complete, refer to appropriate symptom.
    2. No --> Repair is complete.
scientia non olet · About LEMON Manuals