LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Sebring GTC, Standard >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Disc Brakes & Drum Brakes - Except Coupe >> Removal & Installation >> Parking Brake Shoes >> Installation

Parking Brake Shoes: Installation

  1. Install front brake shoe and holddown clip.
  2. Install the rear parking brake shoe and the parking brake shoe upper return spring.
  3. Pull rear brake shoe over anchor block until properly located on adapter.
  4. Install the parking brake lower return spring.
  5. Install the adjuster between the parking brake shoes. Adjuster must be installed with the star wheel toward the rear of the vehicle.
  6. Install hold down clip on rear parking brake shoe.
  7. Adjust parking brake shoes to an outside diameter of 6.73" (171 mm).
  8. Install hub/bearing on knuckle.
  9. Install A NEW hub/bearing retaining nut. Tighten the hub/bearing retaining nut to specification. See TORQUE SPECIFICATIONS .
  10. Install dust cap on hub/bearing.
  11. Install rotor.
  12. Install rear disc brake caliper on adapter. See REAR DISC BRAKE SHOES .
  13. Install wheel and tire.
  14. Tighten wheel mounting nuts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals