Possible Causes
DTC VERIFICATION
TONE WHEEL/PULSE RING INSPECTION
WIRING HARNESS INSPECTION
CRANKSHAFT POSITION SENSOR
DIAGNOSTIC PROCEDURE - P0315-NO CRANK SENSOR LEARNED
| TEST | ACTION |
|---|---|
| 1 |
NOTE:
Check for any TSBs that may apply to this symptom. Ignition on, engine not running.With the DRBIII®, clear DTCs, and perform the PCM battery disconnect to reset the PCM.Start the engine.If the MIL has not yet illuminated, test drive the vehicle to try to get the code to reset.Does the code reset while cranking or during the test drive?
|
| 2 | Visually inspect the CKP wire harness. Look for any chafed, pierced, pinched, or partially broken wires. Visually inspect the CKP wire harness connectors. Look for broken, bent, pushed out, or corroded terminals. Ensure the Crankshaft Position Sensor is properly installed and the mounting bolt tight. Refer to any TSB that may apply. Were any of the above conditions present?
|
| 3 | Turn the ignition off. Remove the Crankshaft Position Sensor. Inspect the Tone Wheel/Flex Plate slots for damage, foreign material, or excessive movement. Were any problems found?
|
| 4 | If there are no possible causes remaining, view repair. Repair: Replace the Crankshaft Position Sensor. Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC . |