Diagnostic Procedure
FRONT MODE DOOR TRAVEL TOO SMALL (ACTIVE) - DIAGNOSTIC PROCEDURE
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition on. With the DRBIII®, read the active ATC DTCs. Does the DRBIII® display: FRONT MODE DOOR NOT RESPONDING?
|
All |
| 2 | Turn the ignition off. Disconnect the Front Mode Door Actuator harness connector. Connect a 12-volt Test Light between the Front Mode Door Actuator harness connector cavities. Turn the ignition on. While monitoring the test light, press the MODE switch to place the mode door in each position.
NOTE:
Observe test light for approximately 30 seconds. Does the test light start to flash and stay flashing?
|
All |
| 3 | Remove the Front Mode Door Actuator from the A/C-Heater Housing assembly. Rotate the front mode door from stop to stop. Note: The door should rotate approximately 45 degrees from stop to stop. Does the front mode door move smoothly in both directions?
|
All |