LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Pacifica FWD >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Body Diagnostic Procedures - Adjustable Pedals, Airbag, Audio, Chime >> Diagnostic Information And Procedures >> Chime >> Symptom: *KEY IN IGNITION AND DRIVER'S DOOR OPEN CHIME NOT OPERATING PROPERLY >> Diagnostic Procedure

Diagnostic Procedure

*KEY IN IGNITION AND DRIVER'S DOOR OPEN CHIME NOT OPERATING PROPERLY - DIAGNOSTIC PROCEDURE

TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIII®, read BCM DTC's.
Does the DRBIII® display any Cluster Wake Up Output or Communication DTC's?
  1. Yes: Refer to SYMPTOM LIST for the appropriate symptom.

    Perform BODY VERIFICATION TEST VER-1 .

  2. No: Go To 2
 All
2 With the DRBIII® under MIC, actuate the CHIME.
Does chime sound a warning?
  1. Yes: Go To 3
  2. No: Replace the Instrument Cluster.

    Perform BODY VERIFICATION TEST VER-1 .

 All
3 Open the driver door.
With the DRBIII®, in Driver Door Module Input/Outputs, read the "DOOR AJAR" state.
Does the DRBIII® display "DOOR AJAR: AJAR "?
  1. Yes: Go To 4
  2. No: Refer to SYMPTOM LIST for problems related to Door Ajar.

    Perform BODY VERIFICATION TEST VER-1 .

 All
4 With the DRBIII® in BCM Inputs/Outputs, read the Key in Ignition Status while inserting the key in and out of the ignition switch.
Does the DRBIII® display change from "Key In" to "Lock"?
  1. Yes: Replace and program the Body Control Module in accordance with the Service Information.

    Perform BODY VERIFICATION TEST VER-1 .

  2. No: Check the Ignition Lock Cylinder for damage. If OK replace the Ignition Switch.

    Perform BODY VERIFICATION TEST VER-1 .

 All
scientia non olet · About LEMON Manuals