Diagnostic Procedure
NO ANTENNA CONNECTION - DIAGNOSTIC PROCEDURE
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition off. Disconnect the Radio Antenna connector. Inspect the Radio Antenna connection. Was the Antenna connection clean and tight?
|
All |
| 2 | Refer to the 3.3 AUDIO SYSTEM
in the service information and test the Antenna in accordance with the service procedure. Is the Antenna ok?
|
All |
| 3 |
NOTE:
Reconnect all previously disconnected components. Turn the ignition and Radio on.
NOTE:
Move vehicle outside approximately 30ft from any structure. With the DRBIII®, erase the audio DTC's, put the radio in seek up and seek down mode for approximately 2 minutes before proceeding.With the DRBIII®, read the audio DTC's.Did this DTC reset?
|
All |