Diagnostic Procedure
BUS LOW - SDARS - DIAGNOSTIC PROCEDURE
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Disconnect the Satellite Radio Multiplexor harness connectors. Disconnect the Radio harness connectors. Measure the resistance to ground on the SDAR Audio Bus circuit at the Radio harness connector. Was the resistance below 5 ohms?
|
All |
| 2 | Disconnect the Satellite Radio Multiplexor harness connectors. Disconnect the Satellite Radio Receiver harness connectors. Measure the resistance to ground on the SDAR Audio Bus circuit at the Radio harness connector. Was the resistance below 5 ohms?
|
All |