Diagnostic Procedure
BUS BUSY - SDARS (EARLY BUILD VEHICLES ONLY) - DIAGNOSTIC PROCEDURE
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Disconnect the Satellite Radio Multiplexor harness connectors. Disconnect the Radio harness connectors. Measure the voltage on the SDAR Audio Bus circuit at the Radio harness connector. Was the voltage higher than 5 volts?
|
All |
| 2 | Disconnect the Satellite Radio Multiplexor harness connectors. Disconnect the Satellite Radio Receiver harness connectors. With the DRBIII® lab scope measure the voltage on the SDAR Audio Bus circuit at the Radio harness connector. Was the voltage higher than 5 volts?
|
All |