LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Pacifica AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures - HVAC, Ignition Power Accessory, Instrument Cluster, Interior Lighting, Navigation, Overhead Console, Power Door Locks/RKE >> Instrument Cluster >> Symptom: EVIC SWITCH INPUT STUCK >> Diagnostic Procedure

Diagnostic Procedure

EVIC SWITCH INPUT STUCK - DIAGNOSTIC PROCEDURE

TEST ACTION APPLICABILITY
1
NOTE: Diagnose and repair any EVIC Switch Input Short or Open DTC's before proceeding with this test.
With the DRBIII® record and erase DTC's.Cycle the ignition switch from ON to OFF to ON.With the DRBIII® read DTC's.Wait 30 seconds.Does the DRBIII® display EVIC SWITCH INPUT STUCK?
  1. Yes: Replace the Instrument Panel Switch Pod in accordance with the Service Information.

    Perform BODY VERIFICATION TEST VER-1 .

  2. No: The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors for an intermittent condition.

    Perform BODY VERIFICATION TEST VER-1 .

 All
scientia non olet · About LEMON Manuals