LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Pacifica AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures - HVAC, Ignition Power Accessory, Instrument Cluster, Interior Lighting, Navigation, Overhead Console, Power Door Locks/RKE >> Instrument Cluster >> Symptom: EVIC SWITCH INPUT CIRCUIT SHORT >> Diagnostic Procedure

Diagnostic Procedure

EVIC SWITCH INPUT CIRCUIT SHORT - DIAGNOSTIC PROCEDURE

TEST ACTION APPLICABILITY
1 With the DRBIII®, erase DTCs.
Turn the ignition off.
Disconnect the Instrument Panel Switch Pod harness connector.
Turn the ignition on, with the DRBIII®, read DTCs.
Does the DRBIII® display "EVIC Switch Input Open"?
  1. Yes: Replace the Instrument Panel Switch Pod in accordance with the Service Information.

    Perform BODY VERIFICATION TEST VER-1 .

  2. No: Go To 2
 All
2 Turn the ignition off.
Disconnect the Instrument Cluster C1 harness connector.
Disconnect the Instrument Panel Switch Pod harness connector.
Measure the resistance between the EVIC Mux Signal circuit and the EVIC/NAV Mux Return circuit.
Is the resistance below 100.0 ohms?
  1. Yes: Repair the EVIC Mux Signal circuit for a short to the EVIC/NAV Mux Return circuit.

    Perform BODY VERIFICATION TEST VER-1 .

  2. No: Go To 3
 All
3 Turn the ignition off.
Disconnect the Instrument Cluster C1 harness connector.
Disconnect the Instrument Panel Switch Pod harness connector.
Measure the resistance between ground and the EVIC Mux Signal circuit.
Is the resistance below 5.0 ohms?
  1. Yes: Repair the EVIC Mux Signal circuit for a short to ground.

    Perform BODY VERIFICATION TEST VER-1 .

  2. No: Replace the Instrument Cluster in accordance with the Service Information.

    Perform BODY VERIFICATION TEST VER-1 .

 All
scientia non olet · About LEMON Manuals