Diagnostic Procedure

RIGHT FRONT TURN SIGNAL OUTPUT OPEN-BCM - DIAGNOSTIC PROCEDURE

TEST	ACTION	APPLICABILITY
1	Turn the ignition on. With the DRBIII®, clear all BCM DTC's. Actuate the Turn Signals. With the DRBIII®, read the DTC information. Does the DRBIII® read: Right Front Turn Signal Output Open? Yes: Go To 2 No: The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires. Perform BODY VERIFICATION TEST VER-1 .	All
2	Turn the ignition off. Disconnect the Right Front Turn Signal harness connector. Using a 12-volt test light connected to 12-volts, check the ground circuit. Does the test light illuminate brightly? Yes: Go To 3 No: Repair the Ground Circuit. Perform BODY VERIFICATION TEST VER-1 .	All
3	Turn the ignition off. Disconnect the Right Front Turn Signal Lamp connector. Turn the ignition on. Turn the Right Turn Signal on. Using a 12-volt test light connected to ground, check the Right Front Turn Signal Driver circuit. Does the test light illuminate brightly? Yes: Replace the Turn Signal Lamp. Perform BODY VERIFICATION TEST VER-1 . No: Go To 4	All
4	Turn the ignition off. Disconnect the BCM C2 harness connector. Measure the resistance of the Right Front Turn Signal Driver Circuit and ground. Is the resistance above 5.0 ohms? Yes: Repair the Right Front Turn Signal Lamp Driver Circuit for an open condition. Perform BODY VERIFICATION TEST VER-1 . No: Go To 5	All
5	Turn the ignition off. Disconnect the Body Control Module C2 connector. Measure the resistance of the Right Front Turn Signal Driver Circuit to ground. Is the resistance above 5.0 ohms? Yes: Repair the Right Front Turn Signal Driver Circuit for an open condition. Perform BODY VERIFICATION TEST VER-1 . No: Replace the Body Control Module. Perform BODY VERIFICATION TEST VER-1 .	All