LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Pacifica AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures - Communication, Door Ajar, Electrically Heated Systems, Exterior Lighting >> Exterior Lighting >> Symptom: LEFT HEADLAMP HIGH BEAM OPEN-IPM >> Diagnostic Procedure

Diagnostic Procedure

LEFT HEADLAMP HIGH BEAM OPEN-IPM - DIAGNOSTIC PROCEDURE

TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIII®, erase the IPM DTC's.
Turn the headlamps on.
Switch the headlamps between high beam and low beam several times, pausing for 5 seconds in each position.
With the DRBIII®, read the IPM DTC's.
Does the DRBIII® read: Left Headlamp High Beam Open?
  1. Yes: Go To 2
  2. No: Go To 5
 All
2 Turn the ignition off.
Disconnect the Left Headlamp harness connector.
Using a 12-volt test light connected to 12-volts, check the Ground circuit.
NOTE: The test light must illuminate brightly. Compare the brightness to that of a direct connection to the battery.

Does the test light illuminate brightly?
  1. Yes: Go To 3
  2. No: Repair the Ground circuit for an open.

    Perform BODY VERIFICATION TEST VER-1 .

 All
3 Turn the ignition off.
Disconnect the Left Headlamp.
Disconnect the IPM C5 harness connector.
Measure the resistance of the Left High Beam Driver circuit.
Is the resistance below 10.0 ohms?
  1. Yes: Go To 4
  2. No: Repair the Left High Beam Driver circuit for an open.

    Perform BODY VERIFICATION TEST VER-1 .

 All
4 Turn the ignition off.
Disconnect the Left Headlamp harness connector.
Using a 12-volt test light connected to ground, check the Left High Beam Driver circuit in the Left Headlamp harness connector.
NOTE: The test light must illuminate brightly. Compare the brightness to that of a direct connection to the battery.

Turn the High Beam headlamps on.
Does the test light illuminate brightly?
  1. Yes: Replace the Left High Beam Headlamp Bulb.

    Perform BODY VERIFICATION TEST VER-1 .

  2. No: Replace the Integrated Power Module.

    Perform BODY VERIFICATION TEST VER-1 .

 All
5 Turn the ignition off.
NOTE: Visually inspect the related wiring harness and circuits. Look for any chafed, pierced, pinched, or partially broken wires.
NOTE: Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.
NOTE: Refer to any Technical Service Bulletins (TSB) that may apply.

Were any problems found?
  1. Yes: Repair as necessary.

    Perform BODY VERIFICATION TEST VER-1 .

  2. No: Test Complete.
 All
scientia non olet · About LEMON Manuals