LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Pacifica AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures - Communication, Door Ajar, Electrically Heated Systems, Exterior Lighting >> Exterior Lighting >> Symptom: LEFT FRONT PARK LAMP OPEN-IPM >> Diagnostic Procedure

Diagnostic Procedure

LEFT FRONT PARK LAMP OPEN-IPM - DIAGNOSTIC PROCEDURE

TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIII®, erase the IPM DTC's.
Turn the Park Lamps on.
With the DRBIII®, read the IPM DTC's.
Does the DRBIII® read: Left Front Park Lamp Open?
  1. Yes: Go To 2
  2. No: Go To 5
 All
2 Turn the ignition off.
Disconnect the Left Front Park Lamp harness connector.
Using a 12-volt test light connected to 12-volts, check the Ground circuit.
NOTE: The test light must illuminate brightly. Compare the brightness to that of a direct connection to the battery.

Does the test light illuminate brightly?
  1. Yes: Go To 3
  2. No: Repair the Ground circuit for an open.

    Perform BODY VERIFICATION TEST VER-1 .

 All
3 Turn the ignition off.
Disconnect the Left Front Park Lamp.
Disconnect the IPM C5 harness connector.
Measure the resistance of the Left Front Park Lamp Driver circuit.
Is the resistance below 10.0 ohms?
  1. Yes: Go To 4
  2. No: Repair the Left Front Park Lamp Driver circuit for an open.

    Perform BODY VERIFICATION TEST VER-1 .

 All
4 Turn the ignition off.
Disconnect the Left Front Park Lamp harness connector.
Using a 12-volt test light connected to ground, check the Left Front Park Lamp Driver circuit in the Left Front Park Lamp harness connector.
NOTE: The test light must illuminate brightly. Compare the brightness to that of a direct connection to the battery.

Turn the Park Lamps on.
Does the test light illuminate brightly?
  1. Yes: Replace the Left Front Park Lamp Bulb.

    Perform BODY VERIFICATION TEST VER-1 .

  2. No: Replace the Integrated Power Module.

    Perform BODY VERIFICATION TEST VER-1 .

 All
5 Turn the ignition off.
NOTE: Visually inspect the related wiring harness and circuits. Look for any chafed, pierced, pinched, or partially broken wires.
NOTE: Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.
NOTE: Refer to any Technical Service Bulletins (TSB) that may apply.

Were any problems found?


  1. Yes: Repair as necessary.

    Perform BODY VERIFICATION TEST VER-1 .

  2. No: Test Complete.
 All
scientia non olet · About LEMON Manuals