Diagnostic Procedure

HAZARD BATTERY POWER OPEN - DIAGNOSTIC PROCEDURE

TEST	ACTION	APPLICABILITY
1	Turn the ignition off. Check the Hazard Battery Power Feed fuse in the IPM. Is the fuse open? Yes: Go To 2 No: Go To 3	All
2	Turn the ignition off. Disconnect the BCM harness connector. Measure the resistance between ground and the Hazard Battery Power Feed circuit. Is the resistance below 5.0 ohms? Yes: Repair the Hazard Battery Power Feed circuit for a short to ground. Perform BODY VERIFICATION TEST VER-1 . No: The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires. Perform BODY VERIFICATION TEST VER-1 .	All
3	Turn the ignition off. Disconnect the BCM harness connector. Turn the ignition on. Using a 12-volt test light connected to ground, check the Hazard Battery Power Feed circuit. Does the test light illuminate brightly? Yes: Replace and program the Body Control Module in accordance with the Service Information. Perform BODY VERIFICATION TEST VER-1 . No: Go To 4	All
4	Turn the ignition off. Disconnect the IPM and BCM harness connectors. Measure the resistance of the Hazard Battery Power Feed circuit between the IPM connector and the BCM connector. Is the resistance below 5.0 ohms? Yes: Replace the Integrated Power Module in accordance with the Service Information. Perform BODY VERIFICATION TEST VER-1 . No: Repair the Hazard Battery Power Feed circuit for an open. Perform BODY VERIFICATION TEST VER-1 .	All