LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Pacifica AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures - Communication, Door Ajar, Electrically Heated Systems, Exterior Lighting >> Electrically Heated Systems >> Symptom: SEAT SWITCH ILLUMINATION OUTPUT SHORT TO BATTERY - DDM (EARLY BUILD VEHICLES ONLY) >> Diagnostic Procedure

Diagnostic Procedure

SEAT SWITCH ILLUMINATION OUTPUT SHORT TO BATTERY - DDM (EARLY BUILD VEHICLES ONLY) - DIAGNOSTIC PROCEDURE

TEST ACTION APPLICABILITY
1 With the DRBIII®, erase DTCs.
Cycle the ignition switch Off, On and back Off. Open the door (to cancel accessory-power delay).
With the DRBIII®, read DTCs.
Did the same DTC return?
  1. Yes: Go To 2
  2. No: The conditions required to set the code are currently not present. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.

    Perform BODY VERIFICATION TEST VER-1 .

 All
2 Turn the ignition off.
Disconnect the power seat switch connector.
Turn the ignition on.
Using the DRBIII®, erase DTCs.
Cycle the ignition switch back Off and open the door.
With the DRBIII®, read DTCs.
Did the same DTC return?
  1. Yes: Go To 3
  2. No: Replace the power seat switch.

    Perform BODY VERIFICATION TEST VER-1 .

 All
3 Turn the ignition off.
Disconnect the Power Seat Switch connector.
Turn the ignition on.
Measure the voltage of the Driver Door Switch Illumination Driver circuit.
Is the voltage above 1.0 volts?
  1. Yes: Repair the Driver Door Switch Illumination Driver circuit for a short to voltage.

    Perform BODY VERIFICATION TEST VER-1 .

  2. No: Replace the Driver Door Module.

    Perform BODY VERIFICATION TEST VER-1 .

 All
scientia non olet · About LEMON Manuals