Diagnostic Procedure
PASSENGER HEATED SEAT SWITCH SHORT - PDM (LATE BUILD VEHICLES ONLY) - DIAGNOSTIC PROCEDURE
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition on. With the DRBIII®, erase DTCs. Cycle the ignition switch from Off to Run. Operate the suspect switch in both positions several times. With the DRBIII®, read DTCs. Does the DRBIII® display PASSENGER HEATED SEAT SWITCH SHORT?
|
All |
| 2 | Disconnect the Passenger Power Seat Switch connector. Turn the ignition on. With the DRBIII®, erase DTCs. Cycle the ignition switch from Off to Run and wait 10 seconds. With the DRBIII®, read DTCs. Does the DRBIII® display PASSENGER HEATED SEAT SWITCH SHORT?
|
All |
| 3 | Turn the ignition off. Disconnect the Passenger Power Seat Switch connector. Disconnect the Passenger Door Module C2 connector. Inspect the Passenger Heated Seat Switch MUX circuit for a short to ground or to another circuit in the seat switch harness. Were there any problems found?
|
All |