Diagnostic Procedure

EBL RELAY CONTROL CIRCUIT SHORT TO BATTERY - IPM - DIAGNOSTIC PROCEDURE

TEST	ACTION	APPLICABILITY
1	Turn the ignition on. With the DRBIII®, erase DTCs. Turn the ignition off, wait 30 seconds, then turn the ignition on. With the DRBIII®, read DTCs. Does the DRBIII® display: EBL RELAY CONTROL CIRCUIT SHORT TO BATTERY? Yes: Go To 2 No: The condition that caused the symptom is not currently present. Refer to any Technical Service Bulletins (TSBs) that may apply. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Perform BODY VERIFICATION TEST VER-1 .	All
2	Turn the ignition off. Install a substitute relay in place of the Electronic Back Light Relay. With the DRBIII®, erase DTCs. Turn the ignition on. With the DRBIII®, read DTCs. Does the DRBIII® display: EBL RELAY CONTROL CIRCUIT SHORT TO BATTERY? Yes: Replace the IPM in accordance with the Service Information. Perform BODY VERIFICATION TEST VER-1 . No: Replace the Electronic Back Light Relay. Perform BODY VERIFICATION TEST VER-1 .	All