Diagnostic Procedure
*RIGHT REAR DOOR AJAR CIRCUIT OPEN - DIAGNOSTIC PROCEDURE
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Open the right rear door. With the DRBIII® in Inputs/Outputs, read the RR DOOR AJAR SW state. Does the DRBIII® display CLOSED?
|
All |
| 2 | Disconnect the Right Rear Door Lock Motor/Ajar Switch harness connector. Using a 12-volt Test Light connected to 12-volts, check the Ground circuit. Does the test light illuminate?
|
All |
| 3 | Disconnect the Right Rear Door Lock Motor/Ajar Switch harness connector. Connect a jumper wire between the Sense circuit and the Ground circuit. With the DRBIII® in Inputs/Outputs, read the RR DOOR AJAR SW state. Does the DRBIII® display CLOSED?
|
All |
| 4 | Disconnect the Right Rear Door Lock Motor/Ajar Switch harness connector. Disconnect the BCM C3 harness connector. Measure the resistance of the Sense circuit. Is the resistance below 5.0 ohms?
|
All |