LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Pacifica AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures - Communication, Door Ajar, Electrically Heated Systems, Exterior Lighting >> Communication >> Symptom: MIC MESSAGES NOT RECEIVED >> Diagnostic Procedure

Diagnostic Procedure

MIC MESSAGES NOT RECEIVED - DIAGNOSTIC PROCEDURE

TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIII®, read BCM DTC's.
Are any Cluster Wakeup Output DTC's set?
  1. Yes: Refer to SYMPTOM LIST for problems related to the cluster wakeup circuit.

    Perform BODY VERIFICATION TEST VER-1 .

  2. No: Go To 2
 All
2 Turn the ignition on.
With the DRBIII®, erase DTC's.
With the DRBIII®, read DTC's.
Did this DTC reset?
  1. Yes: Go To 3
  2. No: The condition that caused this DTC is currently not present. Use the SCHEMATIC DIAGRAMS as a guide, and inspect the related wiring harness for a possible intermittent.

    Perform BODY VERIFICATION TEST VER-1 .

 All
3 Turn the ignition on.
With the DRBIII®, attempt to communicate with the Instrument Cluster (MIC).
Was the DRBIII® able to I/D or communicate with the Instrument Cluster (MIC)?
  1. Yes: Go To 4
  2. No: Refer to the COMMUNICATION  for the related symptom(s).

    Perform BODY VERIFICATION TEST VER-1 .

 All
4 With the DRBIII®, erase DTC's.
Cycle the ignition switch from off to on and wait approximately 1 minute.
With the DRBIII®, read DTC's.
Did this DTC reset?
  1. Yes: Replace the module which set the DTC in accordance with the service information.

    Perform BODY VERIFICATION TEST VER-1 .

  2. No: Test Complete.
 All
scientia non olet · About LEMON Manuals