LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> PT Cruiser Limited, Standard >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Disc Brakes & Drum Brakes >> Removal & Installation >> Brake Pedal >> Removal (With Manual Transaxle)

Removal (With Manual Transaxle)

  1. Unclip the air cleaner cover (2 clips) and move the cover aside.
  2. Disconnect and isolate the negative battery cable.
  3. Remove the silencer pad below the knee blocker.
  4. Fold down and remove the knee blocker.
  5. Remove the brake lamp switch. See BRAKE LAMP SWITCH  .
  6. Remove the clip securing the power brake booster input rod to the brake pedal. See Figure . Remove the input rod from the brake pedal.
  7. Remove the pivot shaft nut. See Fig 1 .
  8. Start to remove the pivot shaft out the left side of the bracket. See Fig 1 . Pull the shaft to the left until the brake pedal can be removed, stopping short of removing the shaft from the clutch pedal.
  9. Slide the pedal out of its bracket and remove it from the vehicle.
  10. The bushings can be removed from the pedal by sliding them out each side.
Fig 1: Removing & Installing Brake Pedal (With Manual Transaxle)
G00309416Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals