LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> PT Cruiser Limited, Standard >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Disc Brakes & Drum Brakes >> Removal & Installation >> Brake Pedal >> Removal (With Automatic Transaxle)

Removal (With Automatic Transaxle)

  1. Unclip the air cleaner cover (2 clips) and move the cover aside.
  2. Disconnect and isolate the negative battery cable.
  3. Remove the silencer pad below the knee blocker.
  4. Fold down and remove the knee blocker.
  5. Remove the brake lamps witch. See BRAKE LAMP SWITCH  .
  6. Remove the clip securing the power brake booster input rod to the brake pedal. See Fig 1 . Remove the input rod from the brake pedal.
  7. Remove the 4 nuts securing the power brake booster to the brake pedal bracket. See Fig 1 .
  8. Remove the 2 remaining upper nuts securing the brake pedal bracket to the instrument panel support.
  9. Carefully remove the brake pedal and bracket assembly from the vehicle.
  10. Remove the pivot shaft nut.
  11. Remove the pivot shaft out the right side of the bracket.
  12. Slide the pedal out of its bracket.
  13. The bushings can be removed from the pedal by sliding them out each side of the pivot.
Fig 1: Removing & Installing Brake Pedal (With Automatic Transaxle)
G00309415Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals