Bleeding Procedures: Notes
CAUTION:
DO NOT pump the brake pedal at any time while have a bleeder screw open during the bleeding process. This will only increase the amount of air in the system and make additional bleeding necessary. DO NOT allow the master cylinder reservoir to run out of fluid while bleeding the system. An empty reservoir will allow additional air into the brake system. Check the fluid level frequently and add fluid as needed.
CAUTION:
To ensure adequate removal of all trapped air from the hydraulic system, proper bleeding sequence of wheel circuits should be uses. See BRAKELINE BLEEDING SEQUENCE
table.
NOTE:
For bleeding the Anti-Lock Brake System (ABS) hydraulic system, see appropriate ANTI-LOCK article in BRAKES.