LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> PT Cruiser Limited, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Anti-Lock Brakes >> Chassis Diagnostic Procedures - Anti-Lock Brake System >> Diagnostic Information And Procedures >> Brakes (Cab) - Symptoms >> Symptom: *NO RESPONSE FROM CONTROLLER ANTILOCK BRAKE >> Diagnostic Procedure

Diagnostic Procedure

NO RESPONSE FROM CONTROLLER ANTILOCK BRAKE

TEST ACTION APPLICABILITY
1 Turn the ignition on.
NOTE: As soon as one or more module communicates with the DRB, answer the question.

With the DRB, attempt to communicate with the Airbag Control Module (ACM).
With the DRB, attempt to communicate with the Instrument Cluster (MIC).
Was the DRB able to I/D or establish communications with either of the modules?
  1. Yes --> Go To 2
  2. No --> Refer to SYMPTOM: *PCI BUS COMMUNICATION FAILURE .

    Perform ABS VERIFICATION TEST - VER 1 .

 All
2 Turn the ignition off.
Disconnect the CAB harness connector.
Using a 12-volt test light connected to 12-volts, probe both ground circuits.
Is the test light illuminated for both circuits?
  1. Yes --> Go To 3
  2. No --> Repair the ground circuit(s) for an open.

    Perform ABS VERIFICATION TEST - VER 1 .

 All
3 Turn the ignition off.
Disconnect the CAB harness connector.
Turn the ignition on.
Using a 12-volt test light connected to ground, probe the Fused Ignition Switch Output circuit.
Is the test light illuminated?
  1. Yes --> Go To 4
  2. No --> Repair the Fused Ignition Switch Output circuit for an open.

    Perform ABS VERIFICATION TEST - VER 1 .

 All
4
NOTE: Ensure there is PCI Bus communication with other modules on the vehicle before proceeding. If not, refer to the symptom list from the menu and repair as necessary.
Disconnect the CAB harness connector.Use Scope input cable CH7058, Cable to Probe adapter CH7062, and the red and black test probes.Connect the scope input cable to the channel one connector on the DRB. Attach the red and black leads and the cable to probe adapter to the scope input cable.With the DRBIII® select Pep Module Tools.Select lab scope.Select Live Data.Select 12 volt square wave.Press F2 for Scope.Press F2 and use the down arrow to set voltage range to 20 volts. Set Probe to x10.Press F2 again when complete.Connect the Black lead to the chassis ground. Connect the Red lead to the PCI Bus circuit in the CAB connector.Turn the ignition on.Observe the voltage display on the DRB Lab Scope.Does the voltage pulse from 0 to approximately 7.5 volts?
  1. Yes --> Go To 5
  2. No --> Repair the PCI Bus circuit for an open.

    Perform ABS VERIFICATION TEST - VER 1 .

 All
5 If there are no possible causes remaining, replace the Controller Antilock Brake in accordance with the Service Information. Perform ABS VERIFICATION TEST - VER 1 . All
scientia non olet · About LEMON Manuals