LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> PT Cruiser Limited, Standard >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Frames & Bumpers >> Rear Bumper Fascia >> Installation

Rear Bumper Fascia: Installation

  1. Position fascia on vehicle (Figure ).
  2. Position fascia slots to push pins on lower quarter panels
  3. Slide fascia forward on push pins
  4. Install screws attaching fascia to lower quarter panels.
  5. Install splash shield in the wheel opening area (Refer to FRONT END SPLASH SHIELDS - INSTALLATION ).
  6. Connect license lamp.
  7. Lower vehicle.
  8. Install nuts attaching fascia to lower floor closure.
  9. Install the rubber body plugs or install new mastic tape patches, if equipped.
  10. Close liftgate.
scientia non olet · About LEMON Manuals