LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> PT Cruiser Limited, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior >> Body Side Moldings >> Removal

Body Side Moldings: Removal

  1. Using a grease pencil or equivalent, mark the location of the molding for reference during installation.
  2. Warm the body side molding and body metal to approximately 38°C (100°F) using a suitable heat lamp or heat gun.
  3. Pull the molding from the vehicle.
  4. Clean off all traces of adhesive tape residue from the panel (s) with a general purpose adhesive remover.
scientia non olet · About LEMON Manuals